Counting matching models…
Simple T handle that requires no extra glue/screws/zip ties to assemble. Max size: 4mm hex key. (5/32 imperial) Stem sizes are not critical just pick one slightly larger or the same as your hex key. Hex sizes: 1.5mm 2mm 2.5mm 3mm 4mm…
Best of both worlds, no plastic tabs that become loose over time yet the convenience of inline attachment. No extra hardware other then the sponge needed. Should work for 1.75 and 3mm filament. Pinch filament between each half of a cut…
Small and large tray for hex bits. Has screw loop to hang on the wall if you like. Small 15 slots Large 65 slits with small part tray. Fit is loose so a bit can be removed one handed, bit a pet peeve I have is when you need pliers or a…
This is intended to not only check how effective your cooling is but also to see what side is not getting the air flow it should. For testing purposes disable any cooling print speed slow down. Slopes are at 45 angles so it should be very…
A compact screw driver with a rotating palm rest. (Photo outdated, it now has a stronger connection for palm rest) I recommend 3 or more perimeters for the screw driver and to print the endcap solid 100% infill or a high perimeter count.…
Simple solder pen with curvy pattern in the cap to prevent the solder end from sliding back in the tube. Small good for 0.5mm solder. Medium good for 0.8mm solder. I used a old Bic pen in a drill as a form to coil the solder. Print…
This should stop the spool holder from falling off during a spool change. Made for Raise3d N2 3d printer
Had a couple alligator clips with old stiff covers so I designed a simple replacement cover for them, to be printed in NinjaFlex. Also uploaded is the Fusion 360 source file for easy modification. Print instructions NinjaFlex Printed at…
Designed to prevent screws and small components from getting lost during repair/maintenance, while still allowing single components to be removed without dumping out the entire container.
The scalable multi-purpose clip. Fast to attach and remove and can be done so one handed. Note: This is a small object with close clearances so a relatively well tuned printer will be needed. Print instructions Two perimeters/shells work…
Hex key holder for the Craftbot, compatible with my T Handles. See here for the T handles: https://www.prusaprinters.org/prints/16557-t-handle
After being unable to find a small tricopter (yet lots of small quads) I set out to make one. I designed this around the KK2 control board and Turnigy 1811 2900kv motors. Update: It looks like the KK2 Board is getting harder to find but…
These are all currently available results.
