Counting matching models…
Wanted a gravity feed water dish for my Chihuahua that didn't use 3 liters of water so the solution was to make one. This will work for small breed dogs and cats. No supports required. Recommend printing in PETG but I've found that ABS…
I've seen a bunch of these models all over so the concept is not new, but I wanted to design one that would best complete the illusion. The curves allow for viewing the separation at a wider range. Printing: Print 2 of each model at .2 mm…
This stand will hold 3 outside micrometers (0-1", 1-2", 2-3") and a caliper with a maximum jaw length of 83mm (3.25"). No supports, easily printable. 10% infill and 2mm walls. This was designed for Insize micrometers. other brands may not…
This is essentially a very close match to the original Rubik's Snake 24 piece shape-forming puzzle. The original was assembled using solid posts and small square spring clamps that frequently came off and forced you to remove pieces to…
This is a remix of https://www.thingiverse.com/thing:4093870/files I tried to post that URL for the original model section here but the automation decided it didn't like it so I selected the closest think I could to the actual model. Use…
I always had to go into the closet to grab sheets for the dryer due to stacked machines and no storage nearby so I decided to build some storage. This print is a great fit to a delta printer if anyone uses one. This design uses 8 mm dia x…
Use this to salt up your rims and serve your drinks with a professional edge. Should fit any cocktail glass that would normally have a salted or seasoned rim. Add your coating to the trough in the rim salter and use a wedge of lemon or…
Borrow a Toonie (or other fitting coin) from a spectator, put it in, slowly close the trap so your spectator can clearly see the reverse moves seemingly required to open it, and watch as your spectator struggles to get it out. Printing:…
When cleaning the cupboards, I noticed a large amount of space being taken up by the 6 sets of fondue forks we had so I hid the designing board. This is my quick 20-minute design for an under-shelf design. Affix to the bottom of your…
These are all currently available results.
