Counting matching models…
Update 23/03/25: I missed the news that Benchy was made public domain, so here's a reupload of my taken down Benchy case, better late than never! A modified Benchy model that fits a Heltec V3. Uses a single M3x10mm screw to put together…
I needed a way to safely vent the fumes from my enclosure and realised that my old air purifier would be perfect as it has both a HEPA filter and an active carbon filter. This set replaces the bottom cover for the air purifier with a…
A 2-Piece cover designed to cover up the terminals of a battery isolator switch held together with 2 tie-wraps. I recommend printing this in PETG or any filament that has a higher melting temperature than PLA as PLA starts to deform at…
A scan of the ELECOM NESTOUT 15000mAh battery pack. Learning to use my new 3D scanner, just putting this model out there if anyone needs it. Not a perfect scan but a lot of the key dimensions are there.
A TPU boot to cover the terminals of a Ford Pinto starter motor. Not yet tested if this TPU can withstand the heat however it should be fine depending what you have in your engine bay. Can be printed without supports in default…
Various 3D Scans of my OasisFly30 used to make some 3D models, uploading in case anyone else has a need for them. The camera in the scans is the Caddx Ratel Micro 1500TVL. Warning Some of these scans have parts I've added to the drone…
Disclaimer: I used AI for the markdown formatting, but it did not do anything else. I wrote and checked all the instructions myself. A mount for the Caddx Ratel Micro 1500TVL to fit the Sub250 OasisFly30. The camera angle is fixed around…
These are all currently available results.
