Counting matching models…
This motor is 80mm in diameter and is fully 3d printed in three parts; the stator, stator base, and rotor. It uses 12 10x3x60mm magnets and has 18 coils. You will need the magnets, 2 8mmx22mm skate bearings and a 8mm rod(at least 100mm in…
The Otto Arm The Otto arm is a 3d printed 4 degrees of freedom robotic arm. It uses only the hardware that comes with your servos plus three little screws. It is a great intro to small robotic arms and it fits right into the Otto…
Cribbage This is a cribbage board. Print Instructions I printed it in PETG because that is what I had but PLA would work much better The pegs should be printed on there side for better structural integrity. The pegs will need support if…
This is a wheel to fit onto a skewer for a balloon powered car or other STEM project. The inner hole is 4.2mm and might need to be drilled open slightly to work with your skewer. I printed the wheel in Petg and the tire in TPU. Pla or…
This is a spacer for a typical 5-1/8 inch Carb. I am using mine on an 83 jeep cj7 but it will work on any vehicle with a 5-1/8 inch carb obviously. I printed mine with CF-PETG and it has held up fine for the last month. Although when…
This is a drop through long board wall that works with command strips. You should print two, one for the bottom and one for the top. When attaching to your wall make sure long board is resting on both the top and bottom mounts to ensure…
This is replacement Bubba Trailblazer lid flap. I printed it with Sunlu PLA with 100% infill. If you heat the plastic with warm water you can then bend the legs around the metal pegs. It does not sit perfectly flat or latch but works fine…
Leg Spacer The Offset dimension is the distance from the wall to the center of the hole. The Hole dimension is the diameter of the hole. Printing No supports needed. Print with 15% or more infill Sizes Here is a link to Onshape where you…
Printed in 95a tpu with 90% infill 100%would probobly work better though.
The purpose of this cube is to demonstrate how ionic bonds interact. The cube has holes for 5x2 press fit magnets. Make some cubes with north facing out and some with south facing out and color code them you can easily get a helpful…
Fikiri #001 Fikiri #001 is my first small puzzle box. It consists of only 5 parts and is easy to assemble, requiring no external fasteners. Printing All parts where printed with PLA .2mm layer height speed setting 15% infill. Ironing on…
This is a Strike plate for the trunk of a triumph spitfire. These are sometimes hard to find so I modeled my own. I printed with 60% gyroid infill using PETG-CF although normal PETG would also work fine.
These are all currently available results.
