10 models
Recommended Filaments: PETG: https://amzn.to/45juHZv TPU 72D: https://amzn.to/4l08AMi (for indestructable strength, can print on Bambu AMS) If you think there is still not enough wind, go get an electrical fan please. A hand fan can only…
3M VHB Tape: https://amzn.to/48bvNb4 Glow in the dark filament: https://amzn.to/3IQFvp0 Enjoy some quick halloween decorations!
This is a remix of the original design of the chin rest, and doesn't require any support material to print. I recommend printing this in flexible material such as TPU because 1. the flat bottom will fit better against the violin, 2. the…
The boat just doesn't go straight enough with the small guides at the bottom of the boat. A rudder solves it all! You need to use 2 M3x25 to replace the original M3x20 screws at the back in order to accommodate the rudder arm. M3x30…
The original propeller had a 20-deg overhang, which made it difficult to print without support and brim, or if one wants to print with TPU. The original shaft also has too much contact area which increases friction. I wanted to print this…
When preheating material, the oozing from the nozzle usually drops to the left side of the printer, not to mention all the bits here and there caused by using the brush to clean the nozzle. It's a pain in the a** to clean up! This tray…
The original file was for upward filament, I edited the original file so that the tube points downward for my LACK enclosure underneath. Make sure you rotate the model upside down to print it at an upward 45 degree angle. Print Settings…
Remember to enable: Shim with at least 5mm distance Support from build plate only, ideally with sheath around it Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: Yes Supports: Yes Resolution: 0.15 Infill: 25% Category: Art
I remixed the original kitchen towel holder so that it doesn't require any screws. All parts printed with 3 perimeters at 20% infill. Print Settings Rafts: No Supports: No Category: Kitchen & Dining
Link to magnets: https://amzn.to/4kG49X6 Link to screwdriver: https://amzn.to/44pQFb4 The IFU screwdriver is compact and awesome, except that I kept loosing the tiny screw bits! I designed this quick bit holder that can tight fit onto the…
These are all currently available results.
