Counting matching models…
Does not fit other 3600 series boxes like the 3650 and 3670. Print: .20mm layers, two layers top and bottom and 15% gyroid infill works best for me. PLA is more than adequate, and PETG gets you warped dividers.
Does not fit other 3500 series boxes like the 3550 and 3570. Print: .20mm layers, two layers top and bottom and 15% gyroid infill works best for me. PLA is more than adequate, and PETG gets you warped dividers. Thanks to hobobandy for the…
Being new to this device called a “tape measure Yagi-Uda antenna", I found myself fumbling around trying to hold both the antenna, radio, and notepad with aiming directions. So, I set out to design a quick attachment to the ¾" PVC pipe…
Need a hand with holding your Kato model railroad DC board while you desolder the power tabs from the side? Here's a saddle to help you with that. Verified only with N scale trains and controller boards. Fits older translucent PCBs and…
Having gotten bored one day and fueled by too much Arizona Green Tea, I set out to make something that I had no idea I could actually make: an antenna mount that brings the cable inside, through the window, and works for both (RP-)SMA and…
A simple model to spread the load of a common wire rack shelf (commonly from Home Depot, Lowes, Target, ULINE, Container Store, etc [sorry, only know North American vendors]) from the 1-inch (25mm) footprint to 2.25" (60mm). This helps…
I needed a way to cool both my ADSBex dongle and RPI Zero 2W so I designed this box, with a Noctua 60x25 5 volt fan in mind. My Pi's operating temperature dropped from 57C without a fan, with a small heatsink, to around 30C with the same…
(I'll get a real description in here shortly) Print four supports, they are used to provide a flat surface inside the pipe for the washers and nuts. Parts needed: Interface to pipe (choose one type) For normal support nuts: 4x #10-32 x 1"…
These are all currently available results.
