Counting matching models…
Keep it as close to the screen as possible otherwise it can interfere with the Z axis. I recommend printing it slanted, to reduce support material need. Category: 3D Printer Accessories
Put a tiny rope through it's legs to soak up water.
A plug must be removed from the bumper to fit perfectly. Cut a hole on the wheel arch and screw the other part on with the cap. Designed for 60mm wide pipes.
I would recommend scaling it up by 1% or 2% if it isn't fitting correctly. Category: Automotive
Simply cut (or melt) down the remaning part of the original button and glue this back with epoxy.
Also increased the gap for the clips for better fitting. Category: Automotive
The middle part which connects to the visor can be removed, the two screws fixes it in place nicely. Category: Automotive
Based on the 8th Gen case design, resized to cover the screen instead, to avoid damage during transportation.
Simple trophy base with extruded place for a plate. Category: Decor
Fit a bolt and an O-ring for good sealing and simple screw it on where the antenna was.
Rear trunk plastic trim screw for 5th Gen Ford Mustang.
Supports aren't needed, might make it a bit nicer though. Category: Household
Mounted on an Anycubic Kobra 2 Neo, but might fit other printers as well. Print Settings Printer Brand: Anycubic Printer: Kobra 2 **Rafts:** No Supports: Yes **Infill:** 0.15 Category: 3D Printer Accessories
Also added a combiner at the top. Category: Kitchen & Dining
I recommend printing the "Bottom" part at 100% infill.
Had enough of water getting anywhere from your IKEA Rinning dish dryer? With this it will only spill just a little...
After a while the dish dryer gets pushed in a bit in the middle - not if you print this support!
Recommended to print it against fiber direction with support otherwise it will break at first try. Print Settings Printer Brand: Anycubic Printer: Kobra 2 **Rafts:** Doesn't Matter Supports: Yes **Resolution:** 0.15 Infill: 20%…
A single cup holder based on SlvrSky1984's design for us Euro Opel GT owners, including a 250ml insert. Category: Automotive
Window Shutter hook replacement, pretty popular in Deutschland or Switzerland.
Put double sided tape or a bit of a foam for insulation between the cap and the spacer ring.
These are all currently available results.
