P
Printablesgatobeam
SKADIS 2x1 Mini Bin
Needed something to hold a handful of small tools but without taking up much space. Printed with the closed bottom surface down, supports on.
- Downloads
- 114
- Likes
- 9
- Rating
- 5
All models
Counting matching models…
P
Printablesgatobeam
T-Clip SKADIS Brother P-Touch Label Printer Holder
Remix of @baconschteam's P-Touch holder to use @LineArcLine's T-Clip system . Print with bottom face against plate and supports enabled. Alternatively, you can print on the back face if supports are enabled for the front cutout panel.
- Downloads
- 64
- Likes
- 18
- Rating
- 5
P
Printablesgatobeam
SKADIS Craftsman Battery Charger Mount
A very simplistic two peg hook for the SKADIS board with the front pegs spaced to hold a standard Craftsman battery charger in its mounting holes.
- Downloads
- 53
- Likes
- 9
- Rating
- 0
P
Printablesgatobeam
SKADIS AnkerMake Tool Kit Holder
Adjustable peg for holding Ankermake toolkit on a SKADIS organizer, providing some flexibility on spacing. Recommend using two, though it will both fit and balance in one. Built from @PinkOrange09_1527050 ‘s AnkerMake Tool Kit Holder and…
- Downloads
- 40
- Likes
- 8
- Rating
- 5
P
Printablesgatobeam
SKADIS 3DS/2DS Charger Holder
Adding another model to the world of SKADIS video game organization. The cord can be wrapped through the cutout as shown and tucked into the cable clips at the top or the clips can be used to hold a bundled cable in the cradle. Is there…
- Downloads
- 32
- Likes
- 3
- Rating
- 0
P
Printablesgatobeam
SKADIS Stratus Duo Mount
Built from @PhaetonIndustries 's Steelseries Stratus Duo Wall Mount and @Rod_21807 ’s IKEA Skadis Fusion 360 Models .
- Downloads
- 19
- Likes
- 2
- Rating
- 0
P
Printablesgatobeam
Ikea Uppdatera/Variera Box Riser
This is @karlmeyer 's stacker design modified for the current Uppdatera 9 ½x6 ¾ " (24.1 cm x 17.1 cm) plastic boxes. I was looking for a way to stack my bins to see them better in deep shelving. I adjusted the: placement of the top groove…
- Downloads
- 16
- Likes
- 5
- Rating
- 0
P
Printablesgatobeam
SKADIS Replacement Hook aka Mistakes Were Made
When I get a print that only fails on a hook, my preference is to CA glue a new one on rather than reprint the whole piece. This hook has a .5mm rectangular backing that allows you to cut the broken hook flush and glue the replacement on…
- Downloads
- 12
- Likes
- 2
- Rating
- 0
P
Printablesgatobeam
Replacement Button for Yeti GoalZero 1000
I acquired my GoalZero secondhand and while using it in the summer I noticed that the buttons kept falling into the case. Each of these buttons has an arm looped over a single stem on the front plate with no endcap. One of the connector…
- Downloads
- 3
- Likes
- 0
- Rating
- 0
These are all currently available results.