8 models
Based on the ingenious design by jwags55 . This remix is designed to fit the typical LM2596 buck converter. It should be a tight fit on 35mm DIN Rails and hold the converter securely. Use two M3x10mm Bolts and nuts to secure it to the…
Based on the ingenious design by [jwags55](https://www.thingiverse.com/jwags55). This remix is designed to fit standard 4010 fans (with or without built-in nut traps). It should be a tight fit on 35mm DIN Rails and hold the fan securely.…
Based on the ingenious design by jwags55 . This remix is designed to fit BigTreeTech SKR 1.3/SKR 1.4/SKR 2.0 boards (Or anything with an 84.3mm dimension). It should be a tight fit on 35mm DIN Rails and hold the board securely. Note: It's…
Based on the ingenious design by jwags55 . This remix is designed to fit more modern Raspberry Pi's (3 and later). The tolerances were tightened up so it should be a tight fit on 35mm DIN Rails and hold the board securely. Also this…
Based on the ingenious design by jwags55 . This remix is designed for the Lerdge High Power Module which is a common Heated Bed MOSFET. It should be a tight fit on 35mm DIN Rails and hold the board securely. Note: It's really easy for me…
The orginal Y endstop mount (by Ben Levi) does not line up properly with the specified endstop switch (kw11-3p). This remix fixes that by making the holes 9.5mm apart as specified in the dimensions for that type of switch. It also centers…
I adjusted the VEFACH (Voron Exhaust Filter Activated Coal + Hepa) vent holes for use with my Nevermore brand carbon pellets. When I measured the pellets they were a little over 4mm in diameter and the length was always greater than that.…
Inspired by this belt gauge by Tom Anderson . My solution addresses the problem of consistent reference tension by adding an adjustable weight. The weight is a bottle filled with water. The water bottle weight is easy to adjust by using a…
These are all currently available results.
