Counting matching models…
I designed this miter bar because the one included with the saw has too much play. The aluminium miter slot is 21mm (when new) but will wear down with use and it will wear more at the front than the back. Instructions: Print the test…
The nut from the original post was too big for my saw so I redesigned one based on the dimensions of the miter slot on my saw. After that I decided that the featherboard itself was a bit short so I lenghtened it by 5mm. I also increased…
I bought a split keyboard (Royal Kludge RKS70) but couldnt get used to the 4 macro keys to the left so I disabled them, removed the keycaps and the switches and designed a cap to keep dust out of the PCB. I also disabled a key above the…
I needed a case to transport my 100mm analog caliper and I wanted to have a latch included in the geometry as well as filament hinges. I left some room to glue foam to protect the caliper but ended up not doing it. WIP: The latch has…
I needed a way to keep my vials upright to keep the tip clean and prevent leaks. Initially I design a tighter holder but it was annoying to try to fit the vial every time so I made it bigger and easier to use. --- Es un porta viales para…
There are many caliper holder designs available and most of them share the same attribute. They leave the caliper parallel and close to the wall which can make it awkward to pick up, more so in a crowded tool wall like mine. With that in…
These are all currently available results.
