Counting matching models…
Wall mount for a TP-Link Deco X50 node/4g-router and 5G router. The router model is for a X50 5G router which is oval and tapered upwards, not round. It isn't as snug as the node bracket, but when hooked up to the cables it wont move. If…
Biltema pegboard tool holders These are tool holders for a Biltema (Swedish store) pegboard. The holes are cc 12mm and has a diameter of 3.5mm. The FreeCAD files are included so you can modify them to fit different pegboards. Desk mount A…
This decorative light emits a soft, pleasant glow, casting silhouettes of deer, spruce trees, and other elements as the light shines from below. Simply print the silhouettes of your choice, assemble the pieces, and place a LED light strip…
This is a scaled model of the solar system. I used earth as the base at 10mm. All the other planets are scaled up/down relative to that. There's an attachment included that you can glue to the back of the sun to stand it on it's side. It…
Turntable record weight puck This is a hollow turntable weight used to dampen vibrations and hold warped records in place. Just place the record on the turntable and then the weight on top. I'ts mostly common to get them with hi-fi…
Starsense & finder adapter This is made for a Celestron 6SE, but I've attached the FreeCAD file so you can adapt it. Any Skywatcher finder scope shoe will fit in the base, and the original Starsense base holds everything in place.…
I bought an airbrush spray booth so I can use my airbrush in the flat, but the original fan is really loud. This is an adapter to fit a 13mm thinner Noctua fan instead of the original one
When I got my shotgun the end cap was cracked, and the rifle was also a little short for me (I'm 197cm tal). So I made a new end cap and made it deeper. I've attached the FreeCad file so you can change the parameters to fit you.
Modular plant trellis for 6.2mm (0.24 inch) wooden rod I wanted something for my cucumber to climb on and couldn't find anything useful that I could extend as it grows. I made this modular system that can be extended both vertically and…
Rock tumbler with timer I was thinking of printing JT3D's Affordable rock tumbler but wanted a little more control so I decided to build one based on an Arduino. The main thing is the stepper motor and using it's rpm and steps/revolution…
My rifle didn't have a cheek riser when I got it, so I made one. It is a little short but that is to make sure you can remove the bolt without removing the riser. I've attached the freecad file so you can change the height, you'll…
This rifle was a little short for me so I made a replacement end cap. The stl's depth/length is made for me, but I've attached the freecad file so you can change it. For reference I'm 197cm tall. It's fully parameterized so you only need…
Since the summer is short in Sweden, might as well kit the board with fenders to be able to ride when it's a little wet outside :) These fenders fits the Evolve carbon gt snuggly. Not sure if the truck axles are the same on other boards,…
Evolve Bustin Pintail Stand This a remix of nickbaggen's stand but made to fit Evolve's Bustin Pintail board. Printed with four layer walls for greater strength. FreeCAD file included if you need to modify anything
Kitty candy cannon An introduction First off, I'm a novice at both CAD and Arduino. This was a project for me to learn a little of both. It's probably faster (definately cheaper) to just throw candy to your cat. As you can see in the…
A replacement part for attaching a hammock roof to the frame. It's adjustable by loosening the screws in both ends, moving the roof and then just tightening them again. Print the parts standing on their sides. There's alot of force…
These are all currently available results.
