Counting matching models…
Clip on Camera Hood for the Q2 to reduce flare and blooming from LED lights. One is for front (stock) and 200mm LED light bar (see my other models) and another that blocks entire top (for people with risers with light strips). Suggest…
Use to attach a 3 inch vent hose to the exhaust port on the Qidi Q2. You will need to stretch over the coupler as this is a bit larger than 3 inches but provides a snug fit to the hose. Printed in PETG. I used m3x8 self-tapping screws.
A tool to easily disconnect the PTFE tube from the qidibox buffer. You no longer need to lift the buffer to expose the coupler. Just insert this into the hole where the tube is and push down to release the coupler and then pull the tube…
This driven gear is replacing the stock qidibox spool gear. No longer rely on a pen spring for operation! This uses a HF0306 one-way bearing to function identically as the OEM gear but more reliable rewinding of the spool (and no more…
A mount for up to 200mm long LED strips up to 12mm in width. Uses existing screws so no additional hardware needed other than the LED strip you are mounting to it. Simply remove the two screws existing on the upper right front corner…
Add an overhead camera to your Q2! This replaces the existing top glass handle and uses the same screws to mount. Disassemble the Nebula camera as you will only need the camera PCB and the USB cable and the two screws holding the PCB.…
2.1mm height and grooved to accept the lid lip better. Printed in 95a TPU. Many thanks to Robert Samples for the excellent dry box!
3010 fan mount modeled after the OEM 2510 mount. Modified to suit my needs and providing the step if you need to customize for your printer. Use two 2.5x12mm screws to install the fan in the mount (will not protrude through the face if…
This is a TPU gasket to flush mount the Qidi Q2 40mm controller cooling fan to the rear cover. No more gap and better overall circulation as now can feel it exhaust out the slots to the right of the poop chute as intended! Should help…
Q2 bed skirt for the excellent R3men graphite bed. No need for the metal squares to retain the skirt as it uses the bed mounting points instead. Print in a plastic that can handle the 130c bed temps (I used PPS-GF20). Steps included for…
Just a basic handle that is easy to grasp versus the oem. Add classic fuzzy skin to give it some nice texture. Step included for you to modify as you wish. Uses same screws as the old handle. Print settings used: .2 LH / 4 walls / 5 top…
Just a small revision to the excellent filament sensor model by 53Aries and updated by Spunguh. I used a metal collet insert from E3D to finally fix the issue of the ECAS teeth cutting the tube. Collet rotates freely with the PTFE so no…
These are all currently available results.
