Counting matching models…
This is untested, but should fit the following models: Audi B5 A4 FWD 1.8T Audi B5 A4 Quattro 1.8T Audi B5 S4 All 2.7T Audi B6 A4 FWD 1.8T Audi B6 A4 Quattro 1.8T Audi B7 A4 FWD 2.0T Audi B7 A4 Quattro 2.0T Audi C5 A6 Quattro 2.7T Audi C5…
Allows you to run a larger Y stepper motor without it interfering with the Y carriage. This is for ender 3 v2's inside of an enclosure after the PSU has been moved outside of the enclosure. Requires some long M5 bolts, longer than stock…
An Enraged Rabbit Carrot Feeder (ERCF) MMU only works with a filament sensor after the extruder gears. Since the official orbiter sensor is a pre-extruder sensor, that will not work. Having purchased it already, I didn't want to figure…
An adapter block to use the Injora INJS2065 servo on WPL C14 RC Cars, https://www.wpl-rc.com/products/17g-dpg-servo
The Jonsbo N5 only gives you all 12 drive bays with a PSU 170mm long or shorter. Many good ATX units are longer (mine is an ASRock PG-1600G at 180mm), and the extra length blocks the fourth drive cage. This frame fits between the case and…
I had issues with the driveshaft slipping, and then i saw some bs in the guide about measuring the shafts and printing a plastic customized part to compensate. Screw that, print this, and lightly tighten the m3 screws to the…
Remixed the design to add a few features I thought were missing or weak in the original, Added a sturdy top bar to the top piece Added a cavity to fill with ball bearings or BB's (use a soldering iron at low temp and extra filament to…
These are all currently available results.
