Counting matching models…
This is a award medal blank I designed. It is 88mm in diameter and 6mm thick. The recess is 4mm deep, I've found this is plenty to allow for detail on the face of the award. The loop at the top is sized for 1.5 inch ribbon.
This is a simple Captain America Shield model, no detail or attachments on the back, mostly just intended for display, the original is pretty small, but it scales up very well. It will print fine without support, but the back will turn…
Needed bricks and was too cheap to buy them. Printed this in 95A TPU at 35% infill. Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold. I used a soap and water solution to help…
A simple doorknob strike plate with a 1mm recess on the back for adhesive foam mounting tape.
This is a small tombstone blank I designed for some Halloween themed awards. It is 67mm tall x 68mm wide. The base is 11mm deep, and the main useable area is 8mm thick with a 6mm thick backing. This allows for recessed text as well as…
This is a simple cover for the long handled floor scraper sold at Harbor Freight. It just slips over the blade, it stays on pretty well, but I added small tabs on the side so you can loop a couple of rubber bands around the handle to make…
Its a little big, and probably not balanced, but if you just need a couple of extra dice it'll do the job. Printed at 100# infill so we can at least pretend we tried to balance it. No support needed.
This is an improved version of my other doorknob strike plate. I added a 2mm domed surface to the front to give it a bit more durability at the center. This version will likely need to be printed with support as the void for the adhesive…
Its a die, easy to print no support needed. Uncomfortably pointy. Printed at 100% infill, all edges are angled so it prints easily with no support.
A set of stands to brace a foam presentation board. This was designed for the Pen and gear foam board from Walmart, but should work for any board around 5mm thick. It includes models for the ends, the bent sides, the middle, as well as…
Designed this to crush cans. The inside is 94mm across from flat side, to flat side, there seems to be a lot of variation in the size of the weights, so make sure yours fits before printing it. The idea is that you just stick a 15lb…
This is a respooler for transferring 1 inch tape to a smaller spool for easier portability. You will need 6 608 bearings 3 8mm diameter dowel segments 40mm in length. Print one of every piece aside from the 14mm spacer, you'll need 2 of…
These are all currently available results.
