Counting matching models…
The inside diameter of the grommet is 2.5". The hole on the cover plate is 1" diameter. Supports needed on the grommet to support the chamfered edge and inside tabs as well as on the cover plate to support the locking tabs. Print Settings…
Belt hanger for Mission Belt style buckles Print Settings Rafts: Doesn't Matter Supports: No Resolution: .2 Infill: 5% Category: 3D Printing
It's a clock! The face is 280mm in diameter. The hands are designed for a Quartz clock mechanism. You may need to scale these up or down slightly for a snug pressure fit - depending on the accuracy of your printer. You can, of course,…
This is a project I put together a few months ago right before seeing Tool in Sac! The control box houses a NodeMCU. I cut the seven diffusers out of acrylic but you could these print in white. The shell has three thin cut-away zones. Two…
Attach with double-stick tape Print face down. Supports needed.
Print in high temp filament. PLA will melt in your car. No supports needed. Gut the electronics out of the wireless charger linked here. Snap the tabs off the printed part and test fit until the pitch is to your liking. Drill a hole…
Designed to quickly connect a vacuum hose while keeping tension off of the shoe. The base piece fits around the Z motor and uses a clip to hold everything tight. The arm is attached to the hose with zip ties and can be slotted in and out…
Holds your toothbrush!! 2 versions - Left and Right. Print it on its back. Print Settings Printer Brand: Creality Printer: CR-10S Rafts: No Supports: Yes Resolution: .2 Infill: 5% Category: Bathroom
A threaded cap for Intex river tubes such as: https://www.amazon.com/dp/B000PEOMC8/ref=cm_sw_r_tw_dp_x_cCPeFb42GTT33 Print Settings Supports: No Infill: 100%
Designed to mount to a utility shelf. All parts printed @ 2mm w/ 3 perimeters, 15% infill except for the two small hanging posts which, for strength, were printed @ 1.5 w/ 4 perimeters and 40% infill. The ball and nut parts print…
Designed to be used with the Alley Cat LILYGO T-BeamSUPREME Case: https://www.printables.com/model/705817-lilygo-t-beam-supreme-ts1-case-by-alley-cat Super Glue this small USB C extension: https://a.co/d/59yoYYs
Do your plastic Halloween headstones keep falling over? Well here you go! Simply drill a couple 1 3/8" holes - pop in the socket (pressure fit should be good but glue never hurts).
These are all currently available results.
