Counting matching models…
UPDATE Sep 24 2023 Before you download and print this, I made a new version with VENT Holes, check it out > DK Riser And another version of a low profile riser >> DK Riser Low Profile A Remix of Daniel's Bambu Labs Carbon X1 Top Glass…
When I made / remixed my first Riser, it was out of personal necessity… because the built-in LED in BambuLab was not sufficient… and that low profile design turned out to be quite popular. Since then, a couple of users Qiao112 and Dan…
If you have experienced your spool being pulled up (against the lid) in your AMS when there's little left on the spool… then this Mods maybe just for you. This solution may or may not work… it is work in progress! Updates are at the…
This is an update to my previous riser I also made one a taller one with Vent and Door , this time I want to improve on the first one Basically all the improvements I did for the Tall one in a low profile, thus without the vent holes… but…
This is my second design trying to come up with a solution for the “Jumping Spool” issues. I shared my first design “ AMS SPOOL GUARD” , but after that… I tried to document and learn a bit more to understand why do the spools jumps in the…
Modeled in Fusion 360, face down, no need support. It has two “buttons” that will fit the left 2 holes at the back, so it stays in place. Angled up a little so you can look in from the top glass. The last firmware update allows you to use…
Made in response to Keon Burkink's post / founding of the possible cause for Slot 3 (and possibly 2) PTFE tube not a straight enough feed to the filament hub inside the AMS and causing failure in pulling the filament out. So he drilled a…
A Stand for YoloBox Ultra , Primarily to be used in the vertical mode, but can also be used in Horizontal Mode, need to slide it to the right for access to the SDCard Slot Attached is a 3mf file with 2 plates (for BambuLab Printers) Plate…
These are all currently available results.
