P
PrintablesTomDoe
Ikea Skadis sewing needle tray inlay
A tray insert to hold packages of sewing needles of the german company "Schmetz", maybe fits other companys as well.
- Downloads
- 414
- Likes
- 115
- Rating
- 5
All models
Counting matching models…
P
PrintablesTomDoe
FormD T1 1.1 - 120mm Noctua NF-F12 PWM Fan Duct
Remixed the O11 fan duct to fit in the FormD T1 together with my beloved Noctua NF-F12 PWM fans. It's a snug fit so that all of the air pressure is working to get the hot air out of the case instead of just circulating between the case…
- Downloads
- 278
- Likes
- 36
- Rating
- 0
P
PrintablesTomDoe
DAN Case C4-SFX V1.0 92mm fan mount
Redesigned the spacer so that it clips on to the back grill of the Dan Case C4-SFX. So it is possible to mount a 92mm fan there without screws through the fan grill since the spacing of the grill makes it impossible to screw the fan to…
- Downloads
- 110
- Likes
- 9
- Rating
- 5
P
PrintablesTomDoe
Gridfinity Baseblates for Ikea ALEX "borderless"
Had the same problem as described here but it still wasn't fitting since my drawers are 294mm wide. So i had to remove the borders from the sides of the plates. Nothing more, nothing less so i save on any more descrition.
- Downloads
- 99
- Likes
- 16
- Rating
- 5
P
PrintablesTomDoe
E-Thirteen, e*thirteen, ethirteen etc. LG1 Chainguide Idler
As the bearing of the idler began to wear down and get stuck it grinded down the rubber housing of the bearing. Instead of just buying a new one I just opened the bearing, cleaned and relubed it so that the bearing was fine. But i was…
- Downloads
- 61
- Likes
- 9
- Rating
- 0
P
PrintablesTomDoe
Whirlpool Spa Pump LX LP300 freeze drain outlet
It's the freeze drain outlet of a LX LP300 spa pump whith the “M” mark for the old model which is nowhere to get. It won't get produced anymore and i managed to brake my original. So i measured the orginial and tried to recreate it. Even…
- Downloads
- 29
- Likes
- 2
- Rating
- 0
P
PrintablesTomDoe
Toniebox charging port travel cover
Print it in PETG to have the flexibility for the “wings” which hold the pressure against the walls of the chargeport. PLA is too stiff and will likely break easier.
- Downloads
- 25
- Likes
- 5
- Rating
- 0
These are all currently available results.