Counting matching models…
Slicer settings: Top layers - 3 Bottom layers - 3 Infill - 20% Wall lines - 2 Infill pattern - Grid Uses four #4-40 x 5/16 bolts/blind nuts and 2 servo mounting screws. Use a ½ square stick (preferably balsa) along with a 42mm x 42mm x…
Best suited for non combat type flying and motors weighing 80 grams or more. Uses the same #4-40 x 5/16 bolts and mounting foot print as the stick type mount. Motor mounting holes are 24mm, 30mm and 34mm on center and the center hole is…
Slicer settings: Top layers - 3 Bottom layers - 3 Infill - 20% Wall lines - 2 Infill pattern - Grid Uses four #4-40 x 5/16 bolts/blind nuts and 2 servo mounting screws. Uses a ½ inch square stick or the laminated plywood in your kit.…
Any PLA will do. Infill at 10% is plenty strong.
You can use whatever filament you desire however regular PLA will work fine. It is a tight fit so your stabilizers will probably require some slight sanding to fit. You can also use the included printable sanding guide to make sure you…
Works ok on a smooth runway with shorter grass. Mounts using existing slots and holes in the bottom of the electronics box. Attaches using 2 servo screws. 15% infill is great for the skid but the mounting rectangle block should be printed…
These are all currently available results.
