Counting matching models…
A 2-in-1 device. Allows you to fill the chamber of your vaporizer with the funnel, and/or press a strong and dense pellet. Normally, due to the low density, a small amount of 0,10 g would totally overfill the chamber, leading to muted…
Tired of those single use flossers you can buy? Me too! Print one yourself! It's indefiniately reuseable, is a great calibration object and nice gift for friends. I recommend printing it with PLA+. I had to put in a lot of work to get it…
I designed this one myself, since the other designs were all very massive and solid, which cost me too much material. It is for big petri dishes and can hold up to 5 pcs with 100x21 mm size. This one uses a hexagonal lattice design, which…
This model is for printing the flow correction cover for a laminar flow hood. A laminar flow hood (LFH) is used by microbiologists and mushroom growers to blow filtered air onto their media (agar plates, grain spawns, etc.) and prevent…
Print with TPU. They are very thin and flexible, can be worn in water, and provide a barefoot-like experience. They were custom designed for wide feet, ab size 39. You can scale them to your liking. The last picture was taken after a lot…
Magnetic stirrers can cost more than 100 bucks. This one less than 5! Here's what you need: 120 mm PC case fan (4 free when already used, e.g. from your old PC) Voltage modifier (see picture, https://www.ebay.de/itm/266028052543 ) 2…
Ever had that? You stand at the bus station, people everywhere. You want to take a deep drag of your vape without looking. You take that drag. And then it hits you: there was a piece of lint in your trousers pocket, and you inhaled that…
A still air box (SAB) is used by hobby mycologists all around the world. With it, the inside air doesn't move, which results in that all pollutions sink to the bottom and don't contaminate the media you work with. This is done with a IKEA…
I always had problems with my Kratky bottles. Either, they were super hard to refill, or the plant just dropped into the vessel. This adapter fixes that! You can just easily fill the nutrient solution into the funnel, and it will flow…
I made this one to always see the nutrient reservoir level in my hydroponic pot. You'll need: A PVC pipe with an inner diameter of 17-18 mm (Don't worry, you can modify the sizes to your liking!) A bit of (styro)foam A few plastic straws,…
A small cable and filament guide for my Tenlog IDEX printer. I noticed, that my cables got damaged due to the friction on the build plate. Also, I needed a holder for my Teflon tubes where my filament goes through. It uses the included…
Due to its age, my old roller shutter bump broke. Therefore, I designed one that will outlast me, my kids and even their kids! I recommend printing it with PETG, Nylon or PCTG, or something else that's strong and weather resistant. For…
I really enjoy photographing with my black mist filter, and don't wanna miss out on it. The problem is, that I had to decide if I permanently wanted to photograph with either my filter, or with flashlight. The 52 mm ring would otherwise…
The bottom “cross” snaps into the net cup and allows it to get fixated. Without the stabilization, it fell over a lot in my DWC. The hole for the net cup is 50 mm diameter in size by default. You can also plug a few 5 mm wooden sticks…
These are all currently available results.
