Counting matching models…
I am not the original designer, I just changed the thread from M10 to BSP 1/8" (the correct thread for P4 M10 connectors
Settings used to get the cleares possible PETG prints. I used the previous progress made by Rygar1432 as starting point
UPDATE: 02.2026 - After a few months of Printing everything from PLA to PPS, it is holding up great. Ive had the sensor arm get stuck about 3 times, had to unbolt it, gave it a nudge and it snapped back forward, increased the clearance by…
The carriage enables a direct extruder conversion using the original extruder with a Spider hotend. Mounting locations for the CR Touch and G-Sensor from the Nebula Smart kit are also designed into the part. You will need a 52mm bowden…
You will need to print each model 4 times, preferrably in ABS or PETG to withstand the chamber temperatures. The models are designed to be printed without supports lying on the Creality logo. You will need to add 3mm M3 Brass inserts,…
Update - adding a 5015 6000rpm ballbearing blower on each side of the lid as seen in the picture you get pretty much even temperature distribution throughout the chamber and it works perfectly as a dryer. 50°C set point get you 50- 51°C…
The filament is fairly expensive, but worth every Penny! It prints beautifully with less stringing than regular TPU and easier?! It feels absolutly awesome to the touch and looks amazing! It tends to do surprisingly well without supports,…
A block off plate to close the lower rear vent holes in order to force fresh air to enter the side vents with fine mesh. The side vent openings should be sufficient. I printed it out of ABS and it is secured with 4 typical Fan self…
These are all currently available results.
