Counting matching models…
I remixed this to add a deeper bevel to the screw holes. Pictures show the issue with the original model. I'm probably using the wrong screws but this remix fixes my issue. Sides are glued to the front bezel with epoxy because I didn't…
Combined a standard Benchy (resized to fit the hitch cover) and a standard hitch cover design. Grind/file the outside corners of the square tube to fit inside your 2" receiver, take a very little at a time to finish with a hand-snug fit.…
This number plate covers the control cables and wiring between triple clamps on a Trials bike. Dimensions are based on my 2000 Sherco 2.9, but it may fit others. Printed in PLA, the picture here shows it bare, right off the printer. I…
Originally posted here http://reddit.com/r/Art/comments/ekurqd/we_respect_your_privacy_3d_print_myself_2020/ By reddit.com/u/musketon Category: Sculptures
This allows a 3x D-cell 4.5v series device to use 2x 18650 batteries at 7.5v DO NOT USE WITH A 4.5V (3 cell) BULB. It will immediately burn out unless the 18650 batteries are quite low to make 5v. I found a "4,5,6 Cell" LED kit at a yard…
When a Subaru transmission is drained and removed, there is still plenty of gear oil that can pool up and leak out of the open seals. This print prevents most small oil leaks and keeps dirt out of the transmission during storage. The 20mm…
Print vertically sitting on-end. I used 1 tree support.
Use standard Skateboard bearings, preferrably brand new, clean. Needs to be JB or Epoxy welded to a thick steel plate for accuracy with Dial Indicators. I wired the Rod in place so the stand could be as small as possible. You may not need…
Low Profile thumb screw can be used for a GoPro camera mount, or use the same screw on a Keihin Carburetor for the idle adjustment. Brass screws are better for the carburetor, the screw thread is M5. Can be printed small side down without…
Designed to print in 2 pieces, attach whatever mount fits your use/case best. Print the Cradle and Spreader separately, glue to assemble or print in PLA and heat up the surfaces with a lighter/torch until glossy and press together. Add…
These are all currently available results.
