Counting matching models…
Exactly as the name suggests, this mount moves the extruder closer to the center of the X-axis, not enough to be perfectly centered as the original Lajbror creation, but enough that X-axis moves no longer have discrepancies in extrusion.…
These excellent covers from Imam had one major flaw, and that is the desiccant holders inside the top cover. This remix allows the covers to stay in place while the used desiccant is refreshed with a fresh batch straight from the dryer.…
I was tired of calibrating the extrusion multiplier for each filament in the slicer. With the flow calibration test attached to each spool I can quickly change the flow factor on the firmware as the print starts so I can switch between…
The important points: An extension to use the 235mm (9.25 inch) CCD100W6 dehydrator for drying filament. I don't have much space, and wanted to use the smallest dehydrator I could find that still had at least 10mm of clearance around the…
The Extrusor with integrated filament sensor by Comunidad Maker 3D (or any filament sensor that drags on the filament) has a problem with flexible filament. The extruder will pull the filament through the sensor just fine, but retraction…
Fits the three most common sizes in light aircraft. Pushes on the end of the nut when the hose, cap, or line is disconnected without needing to disassemble hoses or lines. Sized to fit the nominal dimensions in the Milspec, so measure the…
These are all currently available results.
