Counting matching models…
Full disclaimer: you will need to cut up your glove box a little bit to accomodate the larger dingus, and to drill/screw into it. Just one screw though (typical black drywall screw fits perfect). I designed this thing because I broke the…
This is an impeller. Sized to fit on a 15mm or about a 5/8" shaft, in my case, for a motor. When installed in a cavity of a slightly larger size with on inlet and outlet, will create a vacuum on one side and exhaust the other. I repaired…
This is a capacitor shell used in recapping large old electrolytics as commonly found in 1970's era vintage audio gear. It can house a modern 8400uf 35v, 18mm diameter by 40mm tall electrolytic capacitor, replacing a 40mm diameter by…
This is a low-profile clamp/bracket used to mount an Ikea LEDBERG 12-volt power suppply to the underside of a cabinet with one screw. A regular #8 or drywall screw can be used. For best results, I chose to print this thing with the…
The rear cover/brush holder for the motor on my Delta table saw was damaged and I really needed to replace it to make the saw safe again. Now you can too! Print Settings Printer Brand: Ultimaker Printer: Ultimaker 3 Rafts: No Supports:…
These are all currently available results.
