Counting matching models…
i wasn't too fond of the models i tried previously, so i designed this small paint mixing cup with rounded bottom and proper spout to minimize paint waste and mess, there is also a tight fitting rotating lid to cover the spout between…
stronger version of the original lid, the jugs unfortunately don't stack with this one.
Be Quiet Purebase 600 psu shroud, the letters can be backlit with an addressable led to match your motherboards rgb pattern!
made the face convex and added a backer to the center hole, i also recessed the center hole to fit a hueforge done by Don Matis “jack skellington” here on printables https://www.printables.com/model/604843-jack-skellington
i needed a low profile through wall flange to run my air compressor hose out of the garage. 40mm hole and a steep angle to prevent rain/wind from entering
45 degree corner mount for 12" led under cabinet light (panel type) just a basic model, nothing precise. Figured someone might need it one day. uses m3 screws/bolts to secure the light to the mount. the other holes are for mounting to a…
5 slot box with numbers to organize small gears for the threading dial of a craftsman 106 6" lathe.
a standard inch ruler for sorting construction and wood screws, or bolts up to 6 inches long
These are all currently available results.
