Counting matching models…
This is a flat Boo with all the different colors cut out as separate parts for multi-material printing. Other versions with different facial expressions:…
A strainer to prevent objects from going into the garbage disposal where they might do damage. Has 7.5mm (about 9/32") holes to allow water to enter drain. Also has an ergonomic center post for removal. Total diameter is 84.5mm (just…
See Post-Printing section for installation tips This is the plastic end piece for the rip fence that came with a Craftsman 10" Table Saw Model Number 137.218300. This is quite an old tool, and I doubt anyone will ever find this useful but…
This is a replacement gear for the Dyson V6 motorized brush head. There was a number on my original gear: “T103310 2B”. I do not know if that is a model number or not. It goes inside the motor assembly and connects the motor to the brush…
5 1/2" Extension for ½", 3/8", ¼" Drive 3 1/2" Extension for ½", 3/8" ¼" Drive Short Extension for 3/8", ¼" ½" Head → 3/8" 3/8" Head → ¼" ¼" Head → 3/8"
This allows you to directly connect a 1.25" (31mm) Shop-Vac hose directly to the exhaust of a Skil 7492 Orbital Sander. Link to OnShape model . It may work on other sanders with the following specs: OD of exhaust port: Approx 38mm Pins:…
This is a flat, multi material bashful Boo ghost from Mario, that can be hung from a wall or window. No support needed as it's a flat plate. Other versions with different facial expressions:…
This connects the exhaust of a Makita BO5030 sander to a 1 ¼" Shop Vac hose so that the dust and particles are reduced during sanding. Always use breathing protection when sanding.
This is a mostly flat Svengoolie face. The black is actually 2.5mm higher than the white so you can do a layer switch at 2.5mm or print as-is, or even scale the black areas down to 2.5mm so the entire thing is flat with a true MMU / AMS /…
This is a holder for an Apple iPhone / iPad Lightning to 3.5mm Audio jack dongle / adapter. It is rounded underneath to fit better on the side of iPhone cases, and has two small holes on one side that you can use with a stiff wire to make…
This holds 6 markers up to 20mm diameter, and one eraser 52x30mm. I made a version that can clip on to a 1x3" (19mm x 39mm) frame with no supports, and one that will allow you to glue 8mm magnets or use double-sided mounting tape to…
This is a flat Boo with all the different colors cut out as separate parts for multi-material printing. No supports needed as it's flat. Other versions with different facial expressions:…
This is the bracket that connects the ground spike to a Hampton Bay NXT-SL-12 / Nextech SKU# 1005554635 Solar Light. Mine broke and I remade the part in OnShape so that I didn't have to throw out a working solar light because of broken…
These are all currently available results.
