Counting matching models…
This is designed for use with a single edge razor blade. The miter slots are offset to one end so you have a place to hold on. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: .1 Infill: 30%…
Picked up an ARRMA Typhon but didn't have a turnbuckle wrench. It's designed to be a close fit so it doesn't strip. You'll have to press it on the first time. Maybe even take a few swipes of sand paper. I printed it out of PLA at 100%…
I created this this after my Siberian Husky chewed up the single shot tray of my .22 FlashPup. It's a simple version of the stock tray, but works great on my air rifle. You may need to give it a couple swipes of sandpaper depending on…
I built a custom crawler using Capra axles, Holmes Hobbies/TGH Sherpa Chassis, and Vader Products Monkey Skid. The skid has a width of 78mm, so chassis components are a bit harder to find. When I decided to add a winch, I designed this…
Just purchased a Tempest weather station and was looking for a mount for the communication relay hub. I found the one designed by ezascanbe and saw his comments. I added a back plate with two countersunk holes for mounting it. Printed…
I was looking at the first and second baffles (clear plastic cups) for my .22 FlashPup. The forward opening was huge, so I assumed they mass produced them for all calibers of QE equipped air guns. I designed this to try in my .22…
Used to measure the stiffness of balsa sticks used in indoor free flight airplanes. I cut the sticky edge of a Post-It off and marked it for the gauge. The clamp will need a 12-15mm M3 nut and bolt. Print Settings Printer Brand: Creality…
I designed these bed inserts for the Proline 46 Dodge RC body. Mine are printed with wood filament and look great. I only included one each of the center long and short inserts, so you'll need to print extras of those by themselves. Print…
These are all currently available results.
