Counting matching models…
I bought a set of 14 ¼" drive bits and wanted to put them on my pegboard. I'm not an accomplished designer, but I made this that does the job quite well. I added two more holes to hold ¼" hex to ¼" drive adapter. On the AnnkerMake M5 this…
There are a few models here that show a ‘missing layers’ warning. This is not a remix, I modeled this based on my Mark V SS with the cast iron table. It's a snap fit and provides enough room even for my ½" resaw blade, though there might…
This is a replacement for the sacrificial heel for the MilesCraft Grabber Pro. This one is about 5mm taller and 2 mm thicker. When I was cutting 2" thick Hickory my original push heel was flexing. I designed this one with the ability to…
This is based on a file on another site, I don't know the original maker. I printed the original and it did not allow my door to close all the way. I modified that file to allow the door to close.
This is a replacement foot for some Celestron telescopes. I don't know what models this fits, but I used it on the 114LCM unit. The picture of the foot on the tripod is an early prototype and was stopped mid-print to check for fitment.…
I needed to keep a folder near my moms meds to track her meds and readings we were taking throughout the day. This is a simple 2-piece holder that we mounted inside of the cabinet door so the folder is right there where/when we need it.…
This is a basic V8 emblem that I created for a race car my daughter and I built.
These are all currently available results.
