Counting matching models…
Replacement front and rear body posts for the FTX Bugsta RC Buggy. I know the Carnage has the same part but I am not sure that the holes are in the same place, looks the same chassis but I do not have one to test, perhaps someone could…
Key for a School bell system timer, all but one of ours had been lost so created a backup. Designed to print without support. Instructions Printed at 0.2mm on a PrintrBot Simple Metal. Category: Parts
Yes I know another spool holder for the Printrbot Simple metal, but wait I have reasons. I found with a few spools of filament I have bought recently were too wide to fit on the holder properly so knocked this one up. As with others of…
Wall mount for a wifi camera that only has a vertical adjustment. Print in place hinge that allows horizontal adjustment. Rotate it so that it prints flat. After printing just gently bend the joints until they give. Fold it in half then…
Box and lid with the button for the EDTracker when bought from Hobbycomponents.com and put together using the PCB that comes with the Kit. The board cut down to just shorter than the Arduino Pro Micro so that the USB socket overhangs.…
These are all currently available results.
