Counting matching models…
This is a 5 light pixel stick suitable for use with xLights sequencing software. The one shown is printed in white filament. You can use "clear" filament but you will see hotspots where the pixels are. It can be printed in PLA or PETG.…
This is a remix of Laron Leake's Megatree strip stabilizer to be used when pixels are 1" apart. Actually it can be used on any megatree but the one Laron made is too big when the pixels are 1" apart. See Laron's original design here:…
I needed a clip that held my Pixel Christmas lights to the eaves of the house without using nails or hooks that penetrate the wood. This clip is the answer. It slides snugly over a 1 x 8 eaves board (see photo). It's easy to put up by…
This is a remix of Bigsbigley135's paddle powered boat. I only did one tiny small thing. I added an angle to the overhang where the rubber band hooks over the post in the middle of the boat. This is so the boat can be printed bottom side…
This is a versatile clip that is meant to hold Pixels or Pixel Strips onto a 2 x 8 (or any 2 x X) joist or beam. It fits snugly over the beam to hold the Pixels. It is designed to put the strip on the bottom of the eave or on the side.…
This clock holder was made to hold a clock for use with Octolapse. It slides onto the base. It was specifically designed to be used with this clock...…
These are all currently available results.
