Counting matching models…
Easily printable holder for Antilop legs Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 50 Filament: Spectrum PLA White Category: Other
Saw the front page of a Tintin comic ( Destination Moon ) and desided to design it for my livingroom Assembled around a central threaded rod (no use of glue) Printed color seperated Printed w/o support Three tolerances for the threaded…
Organize your toothbrushes, if you're sharing the same brushhandle or using more than one brush.
My daughters wanted a stencil for a rainbow. Hope you like it.
Hi all! I made this for my friend for Christmas, and thought you guys might dig it! Long story short. I saw a similar design somewhere on the internet and wanted to make one for my friend. It it uses the POWER!!!! of magnets to lift the…
Cutting board stand. I made a version for standing against a wall and another for standing out in the open. Enjoy
Stop the fans from rattling during prints Tested only with single fanducts 5015 fans REMEBER TO MIRROR ONE
Needed a new cable clip as i ran over the old one For 22mm Handlebar and 6mm cables Category: Outdoor & Garden
The lid won't stop the deodorant from oozing, if there is too much still in the bottle. Don't turn upside down before it's almost empty Remix of Carlos Morales design ( here ) with a small chamfer on the top face to break the sharp egde.…
I wanted to clean up my cutlery drawer, so i made these dividers Use 0% infill and 0 Toplayes and use as many walls as you like. Personally i like them with 1.2mm wall Added .stp
Lost one of the tilt legs for my keyboard during a move, so i made a new one. Fits my Roccat Izku keyboard, so I don't know if it will fit. Made three different hights, because i wanted some more tilt. (19mm, 25mm and 31mm) Print Settings…
These are all currently available results.
