Counting matching models…
Replacement Komplement Shelf Pin/Bracket for PAX cabinets Print Settings Printer Brand: Creality Printer: Ender 6 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .16 Infill: 15% Filament: Hatchbox PLA Notes: Printed on Ender…
A two part clip to replace the broken clips that hold the Beystadium together. The parts are best oriented as shown. “Clip A” needs support in one spot as depicted.
This cap is required to be removed in order to refill the hand with water so that it will work properly. Printed in ABS with 0.28 layer height. Supports turned on for the tab portion only.
This a model for the mating threads on a Tide detergent bottle, allowing the spigot to be removed and repurposed. Print with smallest diameter on the build plate. Finer layer height will decrease the “saw-tooth” pattern on the the…
I was missing a screw cover for the mounting screws that hold my LG dishwasher to the cabinet. This part is also 4830ED4001B (AP6231210) replaces 4830ED4001A, 4503016, PS12075919. Printed in PLA with a 0.16mm layer height. The visible…
Replacement set of the plastic seat clips that hold the seat to the stool frame Print Settings Printer Brand: Creality Printer: Ender 6 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .2, Adaptive layer height used for finer…
My Dryer vent would not seal due to a warped flap. This is printed in PLA with 40% infill and 4 external layers. Some light sanding is needed on the pivoting portions of the flap to round the layer lines so that the flap swings freely.
This remix will mount the IKEA KLOCKSIS to the vertical post of the VITVAL bunk bed.
This will hold two of the large size lip balm sticks made by Duluth Trading with a 24 mm diameter tube. Four 10mm diameter magnets glued into the recesses in the back allow it to stick to a metal desk, cubicle, or tool box. I printed it…
The diamondback bed cover has 4 pieces of edge trim where the latch seats. The kit comes with 1 set with a single use adhesive strip. This is printed in ABS with a 0.28 layer height. The adhesive strip is 10mm wide 3M double-sided tape.
Printed in ABS with 3 perimeters and 15% infill. A very coarse layer height works well.
Printed with 3 walls @0.28mm layer height and 25% infill in PLA
This spinner randomly deposits condensate water from my mini split on the pot below.
Printed in PLA with coarse layers, 20% infill.
I created this to replace the hard brittle grip panels on my Kobalt 6-1 screw driver. 6 are required. These were printed in ABS with 0.02 layer height, 3 perimeters, and 4 top and bottom layers.
Printed in PLA with adaptive layer height and 100% Infill
The front caster wheel of my RV750N keeps breaking. The caster wheel body is the weak link. The old spindle must be removed from the broken wheel body and pressed/glued into the new part. The wheel and axle snaps into place in the slots…
This replaces the LitezAll Owl lantern handle. The attached file prints faster laying flat, but the 45 degree orientation prevents the layer's being forced apart when in use.
These are all currently available results.
