Counting matching models…
Super minimal lens protector and camera bump for your S24 Ultra. Uploaded 2 versions, one flat, one with fileted edges. If you print the fileted version (which is the one in the pictures) print at the lowest layer hight you're comfortable…
I hate that my phone won't sit flush on a table and/or wobbles. I also cringe any time I put my phone down directly on the lenses. This will serve double duty, stopping the wobble as well as add some protection to the camera lens. Works…
Remixed to add a hole for my GPU power cables to route through. Quick and nasty, just tossed a hole in it. Probably not going to look at this one again for support or anything but if you like it, enjoy! Category: Computer
Simple, holds 4, wide enough that it wont let ash drop outside of itself.
Print in whatever material you prefer. I Printed mine in ABS as a test, 0.28mm layer height, 2 walls, 4 tops, 3 bottoms. 15% infill. I am 300lbs and these are holding up perfectly fine. I will be trying again with TPU to see if there is…
If you have removed your passenger frame, you can use the bolts on the bikes clutch side to mount this disk lock carrier. I used some velcro to really secure it, but I suspect it would be fine without it as it's a pretty snug fit. Printed…
Apartment friendly (no drilling or permanent adhesive/drywall and paint removing tape) wall plate for 50mm smart buttons. These are the buttons I used . Hole in the center is for removing the button when the battery eventually needs to be…
Hated the clicking of my bachi if it fell, or while rolling around in my car, or having the roll around when placed on an uneven surface. These stop that. Print in TPU at whatever layer height you see fit.
12mm bar to.... something? Its a bit bigger than the og model its remixed from.
These are all currently available results.
