Counting matching models…
This is a very simple part to connect the two main faders of a Behringer Xenyx mixer so it's easier to keep stereo volumes equal. This fits on a 1204USB, so I assume it fits others in this range. Takes only seconds to print. Print…
This is an LGA1366 CPU keychain. Printing instructions: Place CPU on heated bed to preheat it (IHS down). Make sure print is orientated with the thicker lip down. Make sure supports are disabled. Add pause before the upper lip. Print…
Our (immensely cute) stroller curtain came with some flexible curtain rings, but they were a bit too small for the handle section on our stroller bassinet (35mm ID). This model is the same thing but with a 45mm ID. Third photo shows…
This plug was made to replace a redundant socket on a three-way splitter to prevent overcurrent when used with stage lighting fixtures. Use at your own discretion, 3D-printed parts generally are not approved in any way, shape or form.…
68mm diameter, 17mm thick wheel with 120 1*0,5mm ridges around. Hole for 6mm D-shape encoder shaft(optimized from previous version) with 7,5mm 10mm diameter inset for mounting on right-angle encoder mounted on edge of PCB Print Settings…
Filament guide for Minifactory 3 Category: 3D Printer Parts
These are all currently available results.
