Counting matching models…
Easy to print, suggest ABS for strength with 4 surface layers and 25% infill. Works really well with metal pipes which are nice looking and quite classy, but if you are on a budget, it also works with 32mm Outside Diameter (1 ¼ inch)…
This is a simple but effective, adjustable kitchen towel roll holder designed to be mounted under a wall cabinet. The two side brackets attach with 2 short screws each, one vertical at the back and one screwed in at a 45 degree angle from…
This model is a neat little holder for an Oral B electric toothbrush and two brush tips, it keeps them upright and clean. I made this because my wife and I share a toothbrush body, but we each have our own tips, they have colored bands on…
Print two of each of these parts and fit them together to form a complete tray or knife block. They are symmetrical so you don't need to do anything to the models, just print 2 of them. You can glue the two halves together if you like,…
I made this to allow me to use bigger (thicker) spools on my Qidi Plus 4 than the regular cap will allow. I hope it helps you too. Print upright with no support in any filament you like - mine is ABS using standard settings and its great…
small scribe tool for use with normal hexagonal pencil - flats to support a spirit level for vertical work like scribing to moldings in skirting boards etc For hexagonal pencil 7mm across flats - holds pencil tip approx 60mm from the…
Single screw door or drawer handle - I used them as a temp solution while waiting for the permanent handles to be delivered. Feels good in the hand. Print it how you like, in what you like! Attach with 40-50mm long self tapping screws. I…
Uses two screws 63mm from center to center - I used them o replace handles on kitchen units being re-purposed in my garage. Print on its back with its ‘legs’ in the air, no support needed, ABS and PETG both work well. Use 40-50mm self…
Simple replacement knob for the top of your Tefal steamer, uses all of the origional fittings and the origional screw. Print with 5 boundary layers and 5 top and bottom layers to give the screw plenty to bite into and it should work just…
This is a wall light designed to mount 3x Slim LED light fitting of the 55-68mm Hole Type (example https://www.ebay.co.uk/itm/335049402610) in a striking way. It consists for three STLs, a Back Plate, Light Body and a Locking Ring Print…
These are all currently available results.
