Counting matching models…
Remixed to fit only standard 60mm wide spools, with 2 bearings instead of 3. The 3 bearing version caused the standard sized spools to partially slip off one bearing regularly for me. Also flattened one side to allow easy printing…
Found this cable clip, but wanted something more streamlined to keep thin wires in the extrusion (in this case for the webcam). Slight redesign to add a little more space below the clip and to make it lower to the extrusion. Printed in…
Don't apply too much pressure when inserting, or they will deform. Print as oriented with Tree supports, more walls will strengthen the overall structure. Also fits the EBB36, although not quite as prettily.
Use a 5mm drill bit to cut through the sacrifical layer.
I remixed this to be printable in any non-flex material. The fan just slides in from the top. I removed the right sidewall to allow for a small stepdown converter (I run the stock Ender 3 part cooling fan at 12V, which is basically…
This is a remix that attempts to fix some issues I had with my initial remix. Namely: The screw holes were covered and hard to reach, and wore out fairly fast in PETG. I increased the size to allow the use of M3x5x4 brass inserts, to be…
With the original by econa, I had trouble with the cable bunch getting crushed on the right vertical beam when moving all the way right, causing issues i.e. with the bltouch. I extended the top of the mount to add several ziptie mounting…
Probe finally arrived and fits perfectly fine. Needs 2 M3 nuts and 2 M3 screws. Guide the ribbon cable along the existing X-carriage cable. You may have to crimp/solder the connectors after passing it through the sidewall, it will likely…
Added G6 template and G5 template for 75mm wide tape. Made a basic template to allow faster cutting of kinesio tape or similar medical tapes to fit over the dexcom g5 sensor, to keep the original tape from peeling off slowly. Print in any…
Update: Added pictures of the final revision. Working flawlessly so far, can easily run 10mm/s or more with no noise. I got really tired of the Mendel90's threaded rods.. they're slow, they take so many steps (3200 steps per mm!) and make…
These are all currently available results.
