Counting matching models…
Soft plier covers for channel locks. Saw some similar models for Cobra pliers and wanted to make set for my Channellock's. For straight jaw channel locks. I used TPU but I am sure you could use PLA if you wanted a Hard set.
Cheek riser for Traditions Buckstalker. Needed for high rings and scope. I used black PLA. fits on other stocks and guns. weaved holes with twine, needed to put some foam between at some places to make it slide less.
A sabot to reduce your muzzleloader to 6.5mm/.264 spitzer. Had a box of them laying around and designed the sabot. I used PLA. Might make a few adjustments to how you print, I used 15% infill I am sure you can use less. I also printed on…
Handle to go over 5 gallon bucket and save your hand. Helps a lot when you are feeding 5 gallons of corn at a time to cattle. I used TPU fits my hands well.
Part for Barnett crossbow holds hooks for crank. on Barnet crossbows with draw crank. I used PLA and the original screw. you will need to put in a thread insert for it to work or use a tap to thread it. Sorry for the bad photos.
A socket holder for metric deep Snap-On sockets. I used PLA and the set is 3/8 8-19. looks same as sae.
Snap-On SAE socket holder PLA. Made it practically the same as my metric one except the label. Holds many brands of sockets but was made for Snap-On's. pretty well the same as metric but with different label.
a badge to turn your regular boring robot vacuum into SPACEBALLS THE VACUUM complete with a Dark Helmet quote. just glue or tape to your vacuum.
blocks to mark lines with. pencil goes into hole number of length you want goes down. 3/16-1 inch.
new cheek riser for Traditions Buckstalker. Needed for high rings and scope. I used black PLA. works with other guns to. I removed the lattice and thus removed stress points and a source for print failure. this also opened the bottom up…
fake gun to attach to your robot vacuum. just glue tape or attach to your robot vacuum,
"Soda Can Holder" adapter for Roomba
Plug for under the screen/dash on Komatsu skid steer. Holds screen to brace/dash. For 2000's skid steers. I used tpu with 15% infill but any filament would work, if it is stored outside it might change filament.
Craftsman Breaker bar cover to protect your hand when you are torquing down on something. for ½ craftsman breaker bar. I used TPU with 10% infill for some cushion.
TPU ring that protects your eye from impact with the scope. mine broke so I made a new one. I have it on a Bushnell 4-12
These are all currently available results.
