Counting matching models…
This is a simple modification of the z-axis top printable parts which provides a firm grip for the smooth rods. Original part did not hold the rods firmly which caused a lot of vibration and rattle during homing and printing. Simply print…
This door provides a better fit such that the door would not fall open on its own. Door can still be rotated to open and close the garage. Recommended Print Settings Layer Height: 0.2 Material: PLA / PETG / etc. I printed mine in PLA…
Universal mount that can be attached to the X-axis motor using a standard M3x18 screw that comes with the printer. Compatible with NEXIGO, Logitech and other webcams. This design in different from others in that it preserves the design…
Raise your tracks to the next level using this awesome easy-to-print pillar that I have designed. There are various other designs available currently, but they either are hard to print or require a lot of material. This design is simple…
This is a remix of the original wall plate mount bracket with the following improvements: Remote holder part now has more material and is stronger. Remote holder part now has a lip to hold the remote once fully inserted. Remote holder…
Thanks @choovick for the original version of the model. This one has been modified to accommodate standard size SSDs.
Case should print easily without supports. I've printed it in PETG with 20% infill and 0.2 layer height. Case has some holes for securing the display to the bottom part. Note that the holes will be printed with some bridge infill that can…
There are a bunch of different clips uploaded by other people. I found them very hard to use and too difficult to remove. So I created my own version of the clip that is easy use and remove. It's neither too loose nor too tight and works…
No special parameters needed for printing. Should be easy to print, just like the original.
Simple to print face down without supports. Print at 0.2 layer height. Use the shared step files to resize according to the hole in your sink.
I always wanted to have LAN based control of my garage door but it wasn't until myQ decided to shut down the support for Home Assistant, that I came across ratgdo . However, I couldn't wait for months to get the board for it and decided…
I recreated the original Nylon door bolt when one of them broke and I could not find it anywhere on Amazon or Home Depot. I printed mine in PETG but perhaps it would be better to print in Nylon if door is exposed to sun / heat. Print…
These are all currently available results.
