Counting matching models…
Air is a difficult and chaotic medium; corners and bends affect it a lot, especially if a fan and not a compressor powers it, as is the case with the puny Original Prusa Mini(+) print fan. With such a fan, you can't really hope to build…
Extrutim's overall design is awesome of course, his focus is on PLA, though. I print the clamps in PETG and the belts in TPU, but found it difficult to push/pull the flexible belts into the clamp slots as the material is not stiff enough…
See original model, I just changed the screwhead for easier printing without supports.
See original model – low-material screw-in steel sheet holder for Prusa Mini steel sheets. This model only contains the left part, which was extended so it fits the Ikea Metod horizontal spacing between vertical hole columns (the distance…
Simple remix for differently sized felt pads, as I was unable to get fuchsr's but like his brush design. If found that the added length of 10mm over the original design is an improvement as well. Final size is no longer suitable to stick…
This is a simple but sturdy holder for a 30 mm diameter rod, to be screwed onto a flat surface from the top, with countersunk screws (head diameter 9mm, stem 4.1mm). The rod is assumed to be wood, the fit with the holder is intended to be…
These are all currently available results.
