Counting matching models…
I made this for the Sota Beams 7 meter telescopic mast. I printed as it 30%. Done a couple. Just drop it on your mast while you are putting it up and feed your EFHW through as it extends. I have tried ones with a hole and found that…
ICOM IC-705 Microphone Wall Mount. I just used some super glue (cyanoacrylate) to mount it to the wall. Printed 30% with PLA. Printed base down. Print as per Cura Snapshot.
I required a way of locking the end of my EFHW antenna once tuned and trimmed. So I created this lock. I used an M4 brass insert and printed 100%. Wrap the wire around the island and then the top clamps down on the antenna wire and locks…
I have recently purchased the Sota Beams 7 Meter mast and the drive on stand. When you put the mast into the drive on stand there was too much play for my liking so I designed a mast support. The mast support is printed in two halves.…
I purchased a premade Common mode choke from Radio Stuff so created a case to protect it from damage when in my rucksack. The case required cut outs to accomodate the coax. The lid then clamps down on the coax to lock in place. These…
ICOM IC-E80D handi wall mount. I will make one with a stand shortly. Will also put one in my van. Category: Gadgets
I printed this for the 5 cup oiler available on Aliexpress. I wanted somewhere to be able to store the oil cups plus oilers and some pith wood for cleaning the tips. No support needed when laid flat on bed Also anything from 10-20% infill…
Hold with two wood screws, I printed from the bottom up apart from I get warping on the base it all prints fine and is totally usable. Category: Vehicles
print 100% infill for strength, I added a stainless pin for strength. Category: Machine Tools
I wanted a cover for my Radio-Stuff EFHW FairRite T140-43 when in my rucksack. Printed at 30% and then hot glued to atenna bass. The antenna is the BNC EFHW from Radio-Stuff.
These are all currently available results.
