Counting matching models…
This is a remix of kingnai's amazing battery holder for the xbox360 controller. This has a removable sliding cover so, no glue is required. The batteries have to be connected at the bottom of the battery holder, you can use some tin foil…
Print as is with 0.1 mm resolution, tree support and any infil percentage should work fine. I've almost managed to print this down to 30 mm in length. With a resin printer you could probably go even smaller. I will add another file later…
Saab J29F Tunnan. I have remeshed and inflated the original model by ThibautF(https://www.thingiverse.com/thing:4549480) to make it easier to print at smaller sizes. Print Settings Printer: XYZ Da Vinci jr 1.0 Pro Rafts: No Supports: Yes…
Using mitikohalls original design(https://www.thingiverse.com/thing:3245793), I've been able to make a sturdy case for the Nordic Semiconductor nRF52840 pca10056 development kit. The case has a dedicated reset button and exposes most pins…
Det är fredag mina bekanta. Category: Sculptures
Depending on the tolerances of your printer you might have to scale the model up just a tiny bit
These are all currently available results.
