Counting matching models…
This is a version of the miniature paint holder for the honeycomb wall, it works with Pro Acryl and Golden airbrush paints. I have included the wall connector, though it was not created by me, it is used to connect the paint holder to the…
I printed it at .28 draft quality with 10 percent infill and it's more than strong enough to hold painted pieces
225x160x89 mm basket built to fit inside ASDA 3.6L Clip Lid Food Storer. Added a second version with doubled width all around. The thinner version broke when stuck in some pretty sludgy alcohol. Both versions print with no supports needed.
Decided to make this because I keep leaving my boxes of matches outside when starting firepit or burn bin. Hopefully now they'll survive a little longer.
My airbrush station is in a separate area from my main workspace, so I built a tray for carrying the paints I need for a specfic airbrushing session, to keep them organized. I printed the carrying handle separately to minimize supports.…
Simple holder I needed for the solar panel that is attached to my pathway lights. Lights go into the ground with the stakes but the solar panel is on a post. Could also use this to secure the lights themselves if the ground isn't…
I put this rack together because I use a mix of alligator clips and screws for holding my 3D printed pieces while I paint them. The larger holes are 9mm diameter and deep enough to prevent the screws from tipping and falling out. Larger…
Simple, small flexible hook. Needed something to hold the handle up on my can crusher when not being used, as the rivets loosened. This does the job perfectly.
Simple enough. 4.5 x 6.5 cutting area. 0.5mm thick. I printed at 0.20mm
Made to fit the Rutlands Router Table dust port, down to 36.5mm outer diameter of the small end to fit my standard dust extractor hose
These are all currently available results.
