Counting matching models…
Reinforced the spring parts to reduce wobble when pressing the buttons. Added a stop to prevent the buttons from swinging outward. There are some hard to print overhangs, but the area ends up being covered. Tune your printer for overhangs…
Print upright with supports. The slower, the better. Make sure the supports do not extend up the funnel. Printing upright will not result in the best strength for the part, but will require the least support removal.
Remix of https://www.printables.com/model/702716-parametric-box-with-lid by @Billiam
A simple Lazy Susan.
Lost the mounting bracket when I had to renovate so I created a new one. This model does not require supports and can be printed flat, with the text facing upwards. Might be compatible with CAP AC XL also, but I am unable to test.
Just some simple dust catchers useful for drilling holes in the celing. Scale Z down or up to suit your needs/drills. Maybe print it in something more heat resistant than PLA if your drills get hot. Printed mine in ABS-PC.
A case for the NVidia Shield Pro 2019, with support for a 40x10mm 5V fan. My original fan decided to make some angry noises and I went looking for a replacement fan. A fan is ~45 EUR + transport so...here we are. Hardware needed A…
Using a Geberit Type 212 flush valve with a Rimfree toilet can cause water to splash outside the bowl, even when the original flow limiter is set to the maximum restriction position. I designed this enhanced restrictor to reduce the flow…
A practical rotating carousel for organizing 32 Nescafe Dolce Gusto capsules in a compact, accessible format. The holder features four rotating plates that spin independently, allowing easy capsule selection. Features: Holds 32 capsules…
Sew through the holes around the perimeter using matching thread. The thin profile sits flat against fabric without being too bulky. The holes are a bit angled to make sewing easier.
Base and holder have drain holes. 20% infill density with gyroid pattern and 3-4 walls. Print both upright without supports. I printed mine in ABS. The model is indeed pretty filament hungry, but for those that what something sturdy, this…
Perfect for security installations where cameras need to be mounted flush with suspended ceiling tiles. The plate acts as a structural bridge, allowing the camera to clamp the ceiling material between the printed mount and camera base.…
IKEA item number 303.332.86 BROR workbench frame hole cover
Designed and tested to fit on this model of flashlight only. Others might fit also. You only need two tie wraps to fasten it to the handle bar. The mount holds the flahslight tight and you can remove it from the mount with a bit of force…
Designed specifically for the Anker Prime 27.650mAh/250W power bank and a tripod with the center column of ~27mm. The mount is designed to be attached/detached to the center column with a bit of force.
All models have very tight tolerances so make sure to print one piece 1st to test fit. Total needed: 4 x Lanberg plug 1 28 x Lanberg plug 2 or 28 Lanberg plug 3 44 x Lanberg plug 4
These are all currently available results.
