Counting matching models…
Wanted to have my PSU mounted* directly to my Rook using original MK1 parts. It makes it easier to move around even though it becomes a bit heavier. I've only made a version that mounts on the right side, but I can make a left version if…
A simple desk organizer I made to clean up my desk and have things in the same location. I made a left and right version depending on where you place it on your desk. I printed it in .24 with 8% infill and that worked out fine. The…
I wanted my electronics in the back so it also hid the cables and could have easier cable management. There is one folder with just a blank plate, my layout is for a SKR pico, Rpi zero 2w, 40mm cooling fan and uses M5x8mm bolts and then…
Made a M4x25 version and needed it to be 18mm thick, also a M3 version.
Was orignally going to use this before I decided to switch to heated bed and power supply. The AC adapter power supply is still in the BOM for the Rook, figured I share this in case someone is going that route. It uses 2 short heat…
I'm using Kanrog low-profile endstop and I wanted a lid. Saw that Gulsifer has already made one but in the CAD it didn't fit with it so I made a quick remix to fit. Made two version for the rook logo, one that is raised and the other is…
Wasn't too happy with the bearings and rods as I got pretty bad prints from it. So took on a challenge for myself to design this and make it work. I've printed it out and gotten it to work with very good results! The frame is sitting 40mm…
Fluidd notified that my pi got hot during prints so quickly made a mount for a fan to cool it and mainboard. Wasn't sure if I wanted to use 40mm or 30mm, so made a mount for both. 2-4x M3x16mm and nuts for the fan 2x M3x6mm to mount it to…
These are all currently available results.
