Counting matching models…
I made this simple model to sit on top of @INVESTIGATE 's "Creality SpacePi Space Pi X4 Filament Spool Guide Fix - cliped" printed both container and lid at .15mm layer height / 20% infill / Speed: 80 mm/s Print container with its "legs"…
remix of original model made to increase smoothness of print surface. included a picture of the original print file. screenshots of new print file with defects removed. I gave the original smoothed print and was unable to get a photo, but…
Anime character Sui from the anime “Campfire cooking in another world with my absurd skill”. This model has a rounded bottom and will not stand on its own. the supports make a great stand if you leave them attached. PLA model about 2…
Printed in ABS Speed: 40mm/s on perimeters and infill Layer height: .2mm Perimeters: 2 Brim: yes 3.5mm width Supports: yes, snug 60%infill adaptive cubic Print lying down with smaller side rectangular portion facing the print bed.
Base Cap printed in RED PETG .4mm nozzle + supports Flowers printed in Silver PLA .4mm nozzle + no supports (prints 12 flowers for 3 base caps) made the cap of the base which includes bird perchs and holes. flowers included and super…
My K&N air filter was a hair too small. Made this adapter to make it bigger and eliminate the noise when it moves as it is sucked up when the furnace starts and when it falls down when the furnace stops.
I wanted to slow feed my plant water slow with ice. so i created an attachment for my chopsticks to allow for the ice to melt and drip down the choptick.
These are all currently available results.
