Counting matching models…
Mounting Bracket For A Intel NUC And Its Power Supply On An Ikea Skadis. Needs Two M3x8mm Screws To Attach The Mounting Plate To The NUC. Tested With An Intel NUC Model: NUC8i7BEH Installing The Mounting Plate: Installing The PSU:…
Ikea Skadis Holder For 20g Citadel Plastic Glue
This Is A Holder For A SKYRC GNSS Performance Analyzer For Testing RC Vehicles. It Is Designed To Sit Under The Cosmetic Shell Of The Vehicle And Attach The Performance Analyzer And Attach To The Vehicle With Two Velcro ‘Cable’ Ties. The…
Simple Tape Holder For An Ikea Skaddis Board. Will Fit Rolls Of Tapes Up To 21mm Wide
2 need to be printed to mount the docking station. The Holder will leave access for ventilation and use of all the ports on the docking station Also included in the files is the mount for the power supply that came with the docking…
Bracket To Holder A Radio Link RC6GS V3 Transmitter For RC Vehicles On A Ikea Skadis Pegboard With Or Without An INtergrated Sotrage For A Detached Laynyard
This is a battery cage to securely accommodate a small 2S LIPO battery inside of a 1/16 RC Vehicle. Please Note Using A 2S LIPO May Increase The Vehicles Speed If It Does Not Come With One When The “Large” Cage is installed in the vehicle…
Basic Bracket To Store Two Citadel Paint Handles On An Ikea Skadis Peg Board The Shown Example Is For Storing Both The Older Style And Newer Style Of Painting Handles Reference Pictures Of Handles: Old Style: New Style: Printed Examples…
Under Desk Mounting Brackets For Kensington SD4700P Docking Station And Its Power Supply. 2 Of Each Part Needs Printing. Needs 8 4x20mm General Purpose Screws.
Rail Mount that can be attached to a desk with screws or command strips, to store the Joycon grip that ships with the Nintendo switch. Needs to be printed flat as printing vertical caused extremely noticeable layer shifts.
I Kept Snapping Rear Body Posts When Racing My Kamtec Mini racer. And Figured They Are something That Could Easily Be Replaced With 3D Printing. The Original Screws Are Used For Securing The Posts I Have Tested The Body Posts On The Rear…
Wall Mount Bracket For A Lite on pa-1121-04 PSU that i am using to power a ultimaker original. 2 need to be printed to mount the PSU sideways although you might only need to print one to hold it vertically. The screw holes were designed…
Wall Mount Bracket For A fsp230-aaan3 PSU that shipped with a Tiertime up 300. 2 need to be printed to mount the PSU sideways although you might only need to print one to hold it vertically. The screw holes were designed for 4x20mm…
Basic Wall Brackets To Hold Storage Boxes That Are Up To 220mm Deep. Screw Holes are designed around 4X30mm screws
These are all currently available results.
