Counting matching models…
This remote caddie is designed to hold the BedJet 3 remote control and allows the remote to be fully usable while in the caddie. To mount the caddie to a wall, position the caddie to the location you want, then move it up 1 inch and mark…
This is a magnetically mounted air duct with a 90-degree bend to vent bad air to the outside. Made to be used with a cheap plastic dryer vent tube typically found in the United States. This was designed to be used with magnets sourced…
Due to the small parts and the fact that I printed in multiple colors, I slowed the printer down. The ball should be printed with a brim unless you know you can get good adhesion. Bambu Studio Settings: Layer Height: 0.2 Speed: Standard…
This model is of an axle and wheel. To create a 3dBenchy toy car. Using your favorite slicer software place 2 axils and 4 wheels on your build plate. Place your favorite 3dBenchy onto the build plate. Move the axils so they are evenly…
This is a simple model to allow you to create a name tag to show your support for your pet. This is a simple print and doesn't take too long to complete. I printed using 0.2 mm layers using 0.4 mm nozzle.
Hang this print in a place where it can catch some wind. Sit back and become hypnotized from its spinning, twirling, and sway. Be careful of any suggestive speech while in the presents of this hypnotic design. Most of the print is only 2…
This model was designed to hold an index card to display a note or message. I use these to hold a card with WiFi info for events where public WiFi is being provided. There is also room on the rear of the stand to place a logo.
This model is a drum sander that holds a 3" x 11" sandpaper cut from an 9" x 11" sheet. The drum is a two-piece wedge that securely holds the sandpaper. The sandpaper only needs to be clamped at one end. You can either leave it loose or…
LifeVac Station LifeVac ( https://lifevac.net ) is a life-saving tool to save the life of someone choking in place of doing the Heimlich maneuver or when the Heimlich maneuver cannot be performed. It allows for a safer means of rescuing a…
This clamp has been designed to hold large books open. I designed this to allow me to read while I was eating lunch or supper and needed something to keep my book open. Larger books always seem to have a problem were the pages want to…
Dog tag submitted for the contest. This is a quick and easy print. Can be printed in multiple colors or use a marker or paint to color it after it is printed.
Dog tag submitted for the contest. This is a quick and easy print. Can be printed in multiple colors or use a marker or paint to color it after it is printed.
Dog tag submitted for the contest. This is a quick and easy print. Can be printed in multiple colors or use a marker or paint to color it after it is printed.
The Kilroy name tag was created for the Name Tag Contest. After all who doesn't love Kilroy. Obvious any name can be replaced on the nametag and it still works and looks fun.
These are all currently available results.
