Counting matching models…
Simple remix that adds two walls/edges to make the bottom a suitable tray for tiny bits like screws etcetera. Would love it if you post a picture of a make? A like never hurts either :) Category: Tool Holders & Boxes
Print in TPU for best result. Support was not needed on my printer, but your results may vary
My garage was way to moist, decided to make some holes in the walls for air to vent through. Ofcourse we do not want rain to come in, so this is the cover we put on the outside (and shove in the square hole we saw). If this is usefull to…
Case for Jabra Talk 45; I printed in PLA, cap has a good pressure fit on my normal settings. Made a small adjustment so you can also put the cap on the bottom edge when open. But you can also rotate it 90 degrees and snap it to the side.…
Remixing different sources to create a rear that I needed: support for R9 antenna, and also has a sma hole on top. Planned to print in TPU; but actually printed in PLA with a perfect fit (see photos) If you print this would you mind…
These are all currently available results.
