Counting matching models…
I made this model from scratch, but it was inspired by the models in the links. I wanted it in two pieces with a dovetail joint, so i could store it in my travel bag. I like to use my phone in portrait mode, so I needed a longer shelf to…
The perch on my bird feeder was crumbling and breaking from exposure to the sun. I couldn't get a replacement perch and I didn't want to replace the entire feeder. I printed it with my Prusa MK4S. I used PLA, but will re-print it with…
This is a replacement rear slider foot for the Microsoft Arc Touch mouse - Surface Edition. I modeled it in FreeCAD and printed it with a Prusa MK4S. It took several iterations to get it to fit correctly. I printed it with PLA to get…
This holds Allen / hex wrenches of these sizes: 8 mm, 7, 6, 5.5, 5, 4.5, 4, 3. 2.5, 1.5 with a friction fit so they don't fall out in the toolbox, but they are still easy to get in and out with your hands. I printed this from TPU so it is…
The claw arm of my “Pik Stik Pro” broke and I made a replacement for it. I also made a custom shoulder screw to replace the plastic rivet. I ran a tap through the M6 nuts. At this small size, some printers are not so accurate with fine…
This dish was inspired by others here - especially the wave pattern. However, I wanted it to drain on one side towards the sink and I wanted to include a wall so that the soap didn't slip off. The dish sits flat on the surface and the bar…
This is a holder / box / tray for sticky notes. the note pad fits between the tabs on the top and the pad is at an angle for convenient writing. It has a slot for a pen and on top and a storage area below for notes, business cards, an…
I made this nozzle to make my "Ego" model LB7650 cordless leaf blower more effective at cleaning debris off of hard surfaces. It is a friction fit over the tube that is 91.5 mm in diameter. If you need a different diameter, contact me.…
This funnel fits into the top of the feeder and makes it easy to dump seeds in, without them spilling all over. I printed it upside down from PLA with no supports.
I could not find replacement parts for sale, so I made my own. I made the walls thicker (3 mm versus 2 mm) for 3D printing in PCTG versus the original (injection molded in ABS).
I broke the original lid, so this is a replacement. The interface is a jug with a mouth that is 116 mm in diameter (without threads) and that is 72 mm deep from the top of the mouth. I used food-safe PLA filament. I printed it upside-down…
These are all currently available results.
