Counting matching models…
2019-06-26: Since there are people selling my design around the world for the AKK Diversity RX i must assume that is compatible. Hope the people find it useful for this module too. Furious FPV True D V3.5 replacement cover for Fatshark…
Printed with PETg, no support required.
Simple and curvy (aerodynamically friendly) Is simple and it works way better than the original. The best result is achieved printing it with two perimeters and support (with the base rotated at 30º) 0.2 mm layer height. Category: 3D…
The parts were printed with PETg and the sideplates were fixed with double sided tape to the fuselage. The antennas lays flat against the foam of the fuselage and they are not able move in flight. The hatch closes without cutting any…
2019-03-22 : Special thanks to Vaughn Dickson for trying this protectors with the Armattan Marmotte. Not much to say, the same proved protector updated for the newer version of the Armattan frame. OG Chameleon:…
This is a simple frame that allow to use the Runcam Split 2 as a single unit like the Runcam 2. The idea is to easily change the unit between different airplanes or frames using the USB cable as power source and video output. This design…
Update V2: Slightly modified to be easier to print by aligning side walls against the print bed. Wedges added to facilitate aligning the two halves before adding the zip ties. Printed with support. Note that it might require a little…
Gimbal Protectors for FrSky Taranis X9D with Umbrella type stick ends. This stick end is significantly bigger than the original and the lotus type. Since I didn't find anything here i designed and printed my own. Printed in Black PETg @…
This continues the work from the version 5: https://www.thingiverse.com/thing:2747220 Armattan Chameleon TI version: https://www.thingiverse.com/thing:3115041 V6 updates: Perfect fit, no sanding or filing required. Lowered wall (2mm),…
Printed with PETg@100% infill Supports required. The third piece is optional and was included to keep both rear posts with the same shape. WARNING: This is not intended to be used with the original VTX antenna holders. OG Chameleon XT60…
* UPDATE * V6: https://www.thingiverse.com/thing:2754430 This is a work in progress, be aware that it have a really tight fit! (it may require some slight sanding or filing) It's made based on the 3rd generation of the frame base plate.…
These are all currently available results.
