Counting matching models…
Can be printed with any material. Print uses Screws. This siren should be compatible with the rotator box for my Tbolt model, but I plan to make it's own rotator box in the future. This siren should be held on the rotator box by friction.
Can be printed with any material. The V2 has larger ports wich should make the siren louder and a larger motor hole 5mm Designed for the 1000 dual tone and 1003 models of thunderbolt.
This is a model of the Thunderbolt horn and is a sliced up version of somebody elses thunderbolt
Can be printed with any material. Upper mount separated for simpler printing process with less supports. Mount ring ment to be glued to the bottom
can be printed with any material Is a recreation of the DS 977 siren Rotor RPM. : 2880
Can be printed with any material. Print uses screws Solenoids I use :https://www.hadex.cz/g654-elektromagnet-tazny-jf-0520b-6vdc-sila-4n-zdvih-10mm/
This is a replica of the S 145 siren. Can be printed with any material.
Can be printed with any material. Made to be attached onto a pole.
Material: PET G (prefered) is held together with screws Motor holder specificaly made for the n20 60rpm motor + 3D printed gears 10 to 100 = 6 RPM bottom holder not made- reason=>so that model can be used with different sizes of pipes=>…
Can be printed with any material. Upper mount separated for simpler printing process with less supports. Mount ring ment to be glued to the top.
Can be printed with any material. Made for the 1000T model Thunderbolt
Pétrier Tissot and Raybaud - Air raid siren Recomended plastic: PET G Print uses M4 screws, nuts, and a screw terminal strip. Motor: https://www.amazon.com/LVLOZ-Bearing-Upgrade-Electrical-Scooter/dp/B0BWXNT895?th=1
This model can be printed with any material, and it uses screws. This support was made only for the model 1000T and 1000 thundebolt I made, and is most likely incompatible with other thunderbolt models!
This model can be printed with any material, and it uses screws. This support was made only for the model 10003 thundebolt I made, and is most likely incompatible with other thunderbolt models!
Can be printed with any material, print is compatible with all of my Tbolt models. Print uses screws. !!!READ BEFORE PRINTING!!! Please mind, that this model was created only as a base and I do not guarantee that every motor will fit in…
This is a box intended for the control unit and control buttons for the thunderbolt 1003 and 3t 22 Red LED. : https://www.hadex.cz/k453f-kontrolka-12v-led-cervena-do-otvoru-10mm/ Orange LED. :…
Can be printed with any material. Is inteded to be printed in two colors. A great gift for siren lovers!
Can be printed with any material.
These are all currently available results.
